UPGRADE CAR ALARM SYSTEM (AUSTRALIAN STANDARDS)

This Australian Standards Upgrade Alarm transforms an Original Equipment vehicle keyless entry system into an Australian Standards alarm system.

The system is operated by the vehicles original equipment remote and has Entry point protection of doors, boot and bonnet with an intelligent glass break sensor. Audible warning is achieved via an Australian Standards 115dB battery back up siren, visually via the vehicle indicators and via a dash mounted red LED. The system has status / diagnostic reporting.

Suitable for models of these manufacturers

Audi, Alfa Romeo, BMW, Chrysler, Ford, Holden, Honda, Hyundai, Kia, Landrover, Mazda, Mercedes, Mitsubishi, Nissan, Peugeot, Proton, Renault, Subaru, Suzuki, Toyota, Volvo & VW & many more......

The system can provide two additional circuits of immobilisation

Current draw
<10mA average while armed
<250mA disarm (and for no more than 39 seconds after ignition is switched off)

Wide Operating voltage
Operating voltage +9VDC to +15VDC

Operating temperature
-20 degrees to +85 degrees for equipment designed to be installed within vehicle cabin

Operating temperature
-20 degrees to +105 degrees for equipment designed to be installed inside engine compartment

Polarity protection
The system circuitry is design to protect itself against accidental battery polarity reversal. This can happen when replacing the vehicle battery

Independent indicator power fuse
System uses independent fuse to power indicators, ensures short circuit in indicator circuit does not affect system operation

Short circuit protection
The power supply wire to the system is protected against an internal fault within the system


ATT: THE AUSTRALIAN STANDARDS CAR ALARM SYSTEM MUST BE FITTED BY A PROFESSIONAL AUTO ELECTRICIAN